How to design a food container mold

In recent years, plastic lunch boxes and paper Food packaging mould lunch boxes were widely be used. plastic has become the mainstream material for the manufacture of disposable fast food boxes due to its low toxicity, high melting point, strong plasticity, easy production and relatively low manufacturing cost.Requirements for the use of disposable fast food boxes: first, reliable quality, including reliable strength of plastic parts, beautiful appearance, non-toxic and harmless; second, low manufacturing cost, including single plastic parts, light weight, low material price and high material utilization, production The processing is convenient and the output is large enough.Considering the characteristics of disposable fast food boxes comprehensively, the mold design adopts a two-plate mold structure with 4 cavities. In addition, the pouring system, cooling system, and ejection system need to be considered.

In order to fully improve the material utilization rate, and due to the poor fluidity of polypropylene, a disposable snack box with a wall thickness of about  should be injection molded in a short time. The mold pouring system should adopt the form of a hot runner. The hot runner has the following advantages save raw materials can improve the molding quality of plastic parts help to improve production efficiency and facilitate automated production. The disadvantage is that the temperature of the mold is too high, and attention should be paid to sufficient cooling, the mold manufacturing cost will increase. Considering the advantages and disadvantages of the hot runner comprehensively, the final use of the hot runner system helps to improve the molding quality and production efficiency of the plastic parts.

The function of the cooling system is to make the mold cool down quickly and control the mold temperature. Since the temperature of PP material during injection molding is , the reasonable design of the cooling system will greatly reduce the cooling time of plastic parts, and thus shorten the injection molding cycle. Due to the special structure and requirements of the mold, the cooling system uses multi-loop cooling to fully ensure the cooling of the molded plastic parts.Since the mold uses a hot runner system, the temperature of the hot nozzle part will be relatively high, and a cooling system is also added to the hot nozzle of the hot runner.

Due to the large shape of the disposable fast food box and the relatively thin wall thickness, the plastic parts have a greater tightening force on the mold parts. If an ordinary push-rod push-out system is used, it is easy to concentrate the force at the position of the push-rod point, and the push-rod marks will affect the plastic The molding quality of the parts will be broken when serious, resulting in waste products. If the push-plate type ejection is used, the scrap rate will be reduced, but the push-plate structure will increase the excess movement of the mold, extend the production cycle, and reduce production efficiency.The mold uses a multi-point gas-assisted ejection structure. After the mold is opened, the air is blown into the cavity at a certain pressure to separate the plastic parts and the mold. Multi-point gas-assisted ejection has the following advantages.