WASHINGTON, AUG 7:
An independent US quasi-judicial federal agency has ruled against imposing any anti-dumping duty against certain categories of steel threaded rod from India.
The ruling by United States International Trade Commission (USITC) came yesterday a month after US Department of Commerce determined that Indian steel threaded rod was being dumped in the country and sought imposition of anti—dumping duty against it.
“The USITC today determined that a US industry is neither materially injured nor threatened with material injury by reason of imports of certain steel threaded rod from India that the US Department of Commerce has determined are subsidised and sold in the United States at less than fair value,” a media statement said.
The USITC Chairman Meredith M Broadbent, Vice Chairman Dean A Pinkert and Commissioners Irving A Williamson, David Johanson and F Scott Kieff voted in the negative.
Commissioner Rhonda K Schmidtlein did not participate in these investigations.
“As a result of the USITC’s negative determinations, no antidumping and countervailing duty orders will be issued,” the statement said.
In 2013, imports of steel threaded rod from India were valued at an estimated $19 million.
In July, the Department of Commerce determined that imports of steel threaded rod from India had been sold in the United States at dumping margins ranging from 16.74 to 119. 87 per cent.
It also determined that imports of steel threaded rod from India have received countervailable subsidies ranging from 8.61 to 39.46 per cent.
In the anti-dumping investigation, mandatory respondents Mangal Steel Enterprises Limited and Babu Exports received final dumping margins of 16.74 per cent and 119.87 respectively.
Mold material: S136 HRC48-52Manufacturing process: CNC milling, CNC machining, EDM/wire cuttingWe are equipped with the world's top precision machinin
Our liquid transfer gun suction head medicine mould is made of high-quality materials as a whole. There are no burrs at the tip and mouth of the produ
The mold has a short injection cycle, high efficiency, long life, and low cost. Adopting the special flow channel design of the international advanced
This type of mould is assembled from outer cap and an inner anti-theft ring. The outer cap is automatically rotated and pushed out by a hydraulic moto
An injection molding machine is a piece of equipment used to manufacture plastic products. It works by injecting molten plastic into a mold, then cool
Blowing mould – Plastic bottle Most plastic materials are PET& PE, which are formed by blow molding. High efficiency and high output can be achi